Machining of Complex Sculptured Surfaces

Bequeme Ratenzahlung möglich!

This book covers new approaches to the manufacture of moulds and dies in highly technological settings. Discusses modern CAM systems and process planning for three and five axis machining, and explores advantages of high-speed milling over traditional methods.

2013, 1st Edition., XV, 251 Seiten, 38 farbige Abbildungen, 194 Schwarz-Weiß-Abbildungen, Maße: 23,5 cm, Gebunden, Englisch
Herausgegeben von Davim, J. Paulo Springer, Berlin
ISBN-10: 1447123557
ISBN-13: 9781447123552

Autoren-Porträt

J. Paulo Davim received his PhD degree in Mechanical Engineering from the University of Porto in 1997 and his Aggregation from the University of Coimbra in 2005. Between 1986 and 1996, he was lecturer in University of Porto. Currently, he is an aggregate professor at the Department of Mechanical Engineering of the University of Aveiro and the Head of MACTRIB - Machining and Tribology Research Group (http://www2.mec.ua.pt/machining). He has more than 25 years of teaching and research experience in ... mehr ... manufacturing, materials and mechanical engineering, with special emphasis on machining and tribology. He is the Editor in Chief of six international journals, a guest editor of journals, an editor of books, a book series editor and a scientific advisor for many international journals and conferences. Presently, he is an editorial board member of 20 international journals and acts as a reviewer for more than 60 prestigious ISI web Science journals. In addition, he has also published as author and co-author more than 30 book chapters and 300 articles in journals and conferences (more than 150 articles in ISI Web Science, h-index 17).ion from the University of Coimbra in 2005. Between 1986 and 1996, he was lecturer in University of Porto. Currently, he is an aggregate professor at the Department of Mechanical Engineering of the University of Aveiro and the Head of MACTRIB - Machining and Tribology Research Group (http://www2.mec.ua.pt/machining). He has more than 25 years of teaching and research experience in manufacturing, materials and mechanical engineering, with special emphasis on machining and tribology. He is the Editor in Chief of six international journals, a guest editor of journals, an editor of books, a book series editor and a scientific advisor for many international journals and conferences. Presently, he is an editorial board member of 20 international journals and acts as a reviewer for more than 60 prestigious ISI web Science journals. In addition, he has also published as author and co-author more than

Kurzansicht

nach oben

Weitere Artikel zum Thema:

CAM (Computer aided manufacturing)

Das meinen unsere Kunden zu: Machining of Complex Sculptured Surfaces

0 Kundenkommentare
(noch nicht bewertet)

5 Sterne:

(0)

4 Sterne:

(0)

3 Sterne:

(0)

2 Sterne:

(0)

1 Stern:

(0)

Schreiben Sie den ersten Kundenkommentar zu
"Machining of Complex Sculptured Surfaces"
Hier Kommentar verfassen Durchschnittliche Kundenbewertung: noch nicht bewertet